PC-1 – Preform cutter
Allows to cut easily the bottles neck in order to prepare the bubble test with adapted cap holder or to measure some accurate points on a preform.
Easy operation.
Allows to cut easily the bottles neck in order to prepare the bubble test with adapted cap holder or to measure some accurate points on a preform.
Easy operation.
This aphrometer checks the evolution of the pressure during the secondary fermentation.
Remove one bottle without cap from the filling machine and put the aphrometer on the bottleneck.
The permanent aphrometer will remain on the bottleneck during the entire secondary fermentation.
Quality control gauges for checking the threaded tops of glass and plastic containers. Check the threads, outside diameter, spacing, etc.
Many of the defects found in PET container preforms can be detected by using the PL-2. Preforms viewed in polarized light exhibit a colored birefringence pattern.
The birefringence is a result of the polymer flow lines (molecular orientational strain) produced during the injection moulding process.
The colored pattern observed with preform held at 45° to the polarizing axis is known as an isochromatic fringe indicating the amount of birefringence.
Stress introduced during the manufacture of glass components has an important effect on the strength of the product. This effect can be detrimental or beneficial in that it may contribute to failure in service, or to an increase in strength. It is clearly important for quality control to monitor the residual stresses that are present.
DescriptionPhotosDescription The PLS Production Line Simulator allows to simulate in a reproducible and accelerated way the friction on a packaging line. The testing process simulates the abrasions associated with contacts between bottles, typical of packaging lines. It is the ideal device for determining the build quality of glass bottles as well as their coatings, decorations…
Strength pull off cap tester
The “PPG-A” and “PPG-D” are used to measure the perpendicularity (deviation) of the preform and it’s a standard equipment for PET and beverage industries.
With special designed changing & clamping part, it can ensure the accurate measurement of different sizes of preform.
Clamping support and calibration bar are corresponding to each diameter of preform opening. Please provide the detailed preform specification when ordering.
Comply with the requirements of FDA – CFR 21-11
Many typical laboratory functions have been expanded to include a clear graphics screen, which shows the relevant information visually and makes it significantly easier to operate and read the weights off the display Navigation pad for super quick navigation through the menus 40 memories for each mode Extensive print formats – up to 20 lines