PBMS Preform and Bottle Measuring System
Comply with the requirements of FDA – CFR 21-11
Comply with the requirements of FDA – CFR 21-11
DescriptionPicturesDescription CHG – Contact Height Gauge is specifically designed for measuring the contact height of aerosol cans with 25.4mm (1”) aperture. Adopted with Mitutoyo indicator, available for analog model (CHG-A) and digital model (CHG-D). Reference standards: EN 14850, EN 14847, EN 15006 Technical specifications: Measure range: 3 – 5 mm Resolution: 0.01 mm Sample…
The aim of this unit is to test whether the internal diameter of the tested sample is within standard or not.
Judgment of reference: the small end must adapt to the internal circle of the samples, while the larger end should not adapt to the internal circle of the samples.
It can be custom-made as different diameters.
The aim of this unit is to test whether the outside diameter of the tested sample is within standard or not.
Judgment of reference: the samples must adapt to the larger hole, while the samples must not adapt to the small hole.
This unit is used to get a rapid and accurate measure of angle α (see photo above) of the crown cap.
This unit has an excellent basis for measuring. It’s easy to use. Crown cap height and thickness are measured by analog indicator. It is widely used in crown cap, brewery and beverage industries.
Quality control gauges for checking the threaded tops of glass and plastic containers. Check the threads, outside diameter, spacing, etc.
FHS Fill height syringe is used to adjust water level in a bottle to a pre-determined fill height.
It’s a useful tool for accurate and quick checking the content of bottle.
Simple and useful measuring tool for fill height measurement. It’s designed for all size bottles. Gauge may be preset in inches or millimeters to check fill height level on production line or may be used to measure exact fill point of bottle and then compared to standard. Rule may be raised or lowered to compensate for the thickness of various crown caps.
PTG-D PTG Preform Thickness Gauge is used to measure the preform thickness. It’s easy to operate and applicable for various sizes of preform (various supports for different sizes of preform). PTG-A (Analogic indicator) DescriptionPhotosDescription Technical specifications: Measuring range: 0-10mm Accuracy: 0.01mm Dimension: 245(L) x 120(W) x 125(H) mm Weight: 2.4kg Photos