Magnifying Glass
The most proven illuminated pocket magnifiers with new design and improved features
The most proven illuminated pocket magnifiers with new design and improved features
Measure range: 0-150mm, 0-200mm, 0-300mm
CM CircoMeter is for measuring the outside circumference and diameter of different kinds of products like cables, plastic pipe, bottles, etc.
HG-1 Height Gauge which is equipped with a measuring platform can be used to measure the height of bottle, can and other packaging.
The gauge can be connected to AT2E “SeamCheck” software or SPC system via the adapter and cable
The “AMTG-2” is a portable feeler gauge. It is used to measure the thickness of non-magnetic materials, such as plastic, glass, ceramic, aluminum, titanium, copper etc… The accuracy of the measurement is not affected by the shape of the samples.
The TWB-1 Thermostatic Water Bath is a thermostatic water bath equipment that developed by AT2E. It is use to perform the thermostatic tests for products in various field, so that to provide reliable data for estimating the product quality.
The AT2E SCT-D Stress Crack Tester is designed to test the internal stress in bottle base and for determining the stress crack resistance of blow-molded PET carbonated soft drink bottles by measuring the propensity for base cracking upon exposure to an aqueous sodium hydroxide solution under a controlled environment, so that to estimate the long term behavior of bottles.
The AT2E Stress Crack Tester is designed to test the internal stress in bottle base and for determining the stress crack resistance of blow-molded PET carbonated soft drink bottles by measuring the propensity for base cracking upon exposure to an aqueous sodium hydroxide solution under a controlled environment, so that to estimate the long term behavior of bottles.
Many of the defects found in PET container preforms can be detected by using the PL-2. Preforms viewed in polarized light exhibit a colored birefringence pattern.
The birefringence is a result of the polymer flow lines (molecular orientational strain) produced during the injection moulding process.
The colored pattern observed with preform held at 45° to the polarizing axis is known as an isochromatic fringe indicating the amount of birefringence.
Stress introduced during the manufacture of glass components has an important effect on the strength of the product. This effect can be detrimental or beneficial in that it may contribute to failure in service, or to an increase in strength. It is clearly important for quality control to monitor the residual stresses that are present.